EPS-30-V-J jack out pressure cell

The EPS-30V-J jack out pressure cell has been designed to measure the stress on base slabs, diaphragm/slurry walls etc. Construction of a jack out pressures cell is a combination of a thin, flexible, round, flat diaphragm and a thick and rigid back plate. The plates are welded around the periphery leaving a very little gap between the two. The electron beam welded vibrating wire pressure sensor has been welded concentrically with the back plate and the cavity inside the sensor is filled with de-aired fluid.

Back to Measurement devices, sensors and software

Contact us

Leave your contact information, and we’ll be in touch with you.
You may also call us to tel:+358 400 217 888 or send email to Enable JavaScript to view protected content..